Classfieds

A 125 Series 1 project. It's been partially taken apart as you can see.

This is exactly how I got it. The story I was told is the owner's son was gonna re-do it.  I guess he didn't. 

Major issues:

The headset bottom has been broken.  Fortunately it is a "clean break" and can be repaired by a skilled person. I have shown it in a resting broken state and  then held in place by hand  to show the break. The throttle side is frozen, but I think WD40 would free that up.

The levers move. 

Missing a tire/rim - I only have one. 

No kickstart lever.

As you'd guess all the rubber and plastic is either deteriorated or in the state of needing  replacement. Some may be used  again, if you're making a beater but anything presentable I assume new rubbers and plastics are needed. Plus smaller tiny rubber bits  and hardware and sure to be missing.

Count on new cables/ wire loom.  New hardwear/ trim.

Motor - top end is off and so is flywheel, total rebuild.

Carb - 1/2 taken apart. 

Positive

I sent the speedo off to Speedo King ages ago, redone- looks great.  

All the rust seems to be superficial and nothing crazy.

Threads on the horncast and headset top are good.

Total project. 

Not title or paperwork.  Only what you see.

Asking $2400