Kieran cuts them out and a sweet old lady he knows sews them up. He mails them to Chris at Blockhead Printing here in Minneapolis to get printed and Matt gets them from him and ships them to all our wonderful members who buy them.
...so next step will be straighten out bent parts, weld holes and then use a touch up gun with some 2K single stage paint to blend the paint in.
Do you guys know if there's a chemical to strip the powder coating without damaging the bronze bushing? MEK/Aircraft stripper?
..as I was saying, nothing is 100% perfect, just wanted to document what happens in real life...
Few bent parts
The bottom of the toolbox had a rust hole and they did not notice...I will have to sand it, drill a hole, weld and retouch paint
Oviously, even if we discussed the issue beforehand, they painted the toolbox door while closed so it's now shut solid
ALL of my masking was taken out and painted over (brake pivot point, steering tube,etc) but the worst bit is the torsion bar bushing
And there are few spots that were missed